TTR Motor Mount

D.I.Y. - TTR Motor Mount

1. Gather Your Tools / Parts - TTR Motor Mount - 15 MM Deep Well Socket - 3/8 Inch Drive Ratchet - 6 Inch 3/8 Inch Drive Extension - Jack - Block of Wood 

2. Park Your Car . Engage Your Parking Brake / E - Brake . ! Safety First !

3. Remove Your Intake If Needed (Ref Pic 1)

4. Use The Jack And Block Of Wood To Support Your Engine From Below Don't Go Crazy Just Enough To Support It

5. Once Engine Is Supported Remove The 4 15 MM Bolts And 2 15 MM Nuts And Remove Factory Motor Mount (Ref Pic 2 & 3) Make Sure To Hold The Coolant Line Out Of You Way To Access The 3 Bolts Attached To The Motor

6. This Would Be A Perfect Time To Clean Up You Underhood / Passenger Side Of Engine Bay - Place Your TTR Motor Mount In Place And Tighten Down Give All The Bolts & Nuts A Good Push Dont Be Afraid They Need To Be Tight!

7. Replace Your Intake - Prepare For ALOT Of Vibes & Sit Back And Enjoy Your Hard Work!